Field of view

Will the camera see the whole bin?

Choose a camera, its height and your scene. The field of view is shown in 3D and in dimensioned views. The link keeps every setting, so you can send it to a colleague.

Camera
Direction
Position
mm

X / Y are measured from the container centre (bin, rack or belt; the middle of the row when there are several), Z from the floor, in the room’s axes: they do not turn with the scene. Changing the tilt turns the camera where it stands. A new scene or camera model goes back to the default place: straight above the container centre, or aimed at it when tilted.

Scene
mm
mm
mm
mm
mm
mm
mm
Part
mm
mm
mm

You can also drop the file on the 3D view. It is read in your browser only, to draw the part and measure its bounding box; it is not uploaded or stored.

Drag to turn · right-drag or Shift + drag to pan · scroll to zoomOne finger to turn · two fingers to pan · pinch to zoom

  • Container in view
  • Part in view
  • Outside the view or the working distance
  • Field of view at the container top
  • Field of view at the table top
  • Field of view at the container bottom

Loading the 3D view…

Top view looking down
Front view looking along Y
Side view looking along X

Loading the calculator…

All sizes in millimetres. Field of view from the chosen camera's nominal specification (the view at its nearest and farthest working distance, shown in the results), linear in between. Walls that hide the bin's corners from the camera are not taken into account. With several bins or belts, the spacing is the clear gap between neighbours (inner wall to inner wall, belt edge to belt edge), without the wall thickness; position X / Y is the centre of the group. Send us your setup and part for a full check.

Send us your CAD model.

Send the CAD file of your part — a photo of the bin helps too. Our engineers will tell you how Roboeye would handle it.